The Brio uses the same system and has the same features as the easypress controllers, however the initial cut in pressure can be altered (by removing the cover and turning the adjuster) between 1.5 and 3.5 bar and it can be operated vertically or horizontally.  It is also has a pressure gauge, which allows the starting pressure value and system pressure to be checked. It can be used in conjunction with shower pumps in installations where there is a negative head, i.e. the shower head is above the water level in the cold water tank, and also where the pumps are supplying several outlets at once e.g. body jets, or domestic water supplies.  It also has a built in timer which will automatically try to reset itself every 30 minutes in the event of a previous shut down due to lack of water. Suitable for pumps with 230v motors that do not exceed 1.5kW and 110v motors that do not exceed 0.75kW.  Reset device not available on 110v.

 Click Here For Detailed Technical Specifications

The PENDANT float switch has a 370mm long, H07RN-F 1.5mm² rubber cable, with an integral gland, for fitting to single phase Tsurumi and JS submersible pumps. The AGMA is a more compact design of float switch that has a mechanism that operates within a tube. It has an integral gland for fitting to single phase Tsurumi and JS submersible pumps. Supplied with 10 metres of rubber cable. The SENSOR is an electronic float switch with stainless steel probes encapsulated in impact resistant moulded rubber. When the probes touch water, the pump will start and continue to operate for one minute after the water falls below it. However, if the water touches the probe within this time, the “stop” signal is cancelled and the pump continues to run until the water is cleared. It has an integral gland, for fitting to single phase Tsurumi pumps. The REMEX is a float switch for filling, emptying and alarm duties for all types of electrically driven pumps for operation in liquids up to 70C°. It is simple in construction and easy to fit. The SWITCH20 has been designed specifically for use with the LSC1.4S residue pump utilizing a QA50B control panel for controlling low water levels. 3 probes, in 304 stainless steel, are set in an epoxy-resin filled holder and they represent on, off and common. PROBES, used in conjunction with probe wire, and controlled by a QA50 panel, are used for precise water level control.

 Click Here For Detailed Technical Specifications

The Little EX comply with ATEX directives and are classified as IIC-T6-II-I-G. They are intended for use in potentially explosive atmospheres created by gases, mists and vapours. They have polyethylene cases with polyurethane cables for use in diesel oil, other hydrocarbons and the oils and fats present in kitchen waste. They are double acting for emptying or filling applications. Supplied with a counterweight.

 Click Here For Detailed Technical Specifications

Presscontrol and Mascontrol controllers are electronic pressure switches with integral dry running protection and non-return valve. They will start a pump immediately when a valve in the pipe system is opened and stop the pump immediately when the valve is closed, or if the pump runs dry. They can be fitted directly to any surface mounted pump, or in the delivery line of any submersible that operates within the rated pressure and flow specifications. Suitable for pumps with 230v motors that do not exceed 1.5kW. The column of water between the switch and the highest outlet must not exceed 15 metres (1.5bar), otherwise the system pressure may not fall to the pre-set “cut in” pressure and the system will not restart. They must be operated vertically. This control is pre-set at factory, so no additional programming is required/possible on installation. Presscontrol TIME has an auto reset fitted.

 Click Here For Detailed Technical Specifications